Tiny MakersTMReal parts. Three kits. One for each level.
Each student gets the kit for their level. It grows with them, from a first LED to their own circuit board.
Spark Makers kit
Everything for first circuits. No soldering, no code: parts push into the breadboard.
9 V battery
The power. Like a pump that pushes electricity round the loop.
Breadboard
A board with holes. Parts push in and come out. No glue.
LED lights
Tiny lamps that glow when electricity flows the right way.
Resistors
Slow the electricity down to protect the LED.
Push button and slide switches
Press or slide to open and close the loop.
Motor and fan
Spins when electricity flows. Swap the wires and it spins the other way.
Capacitors
Tiny tanks that store a little electricity and give it back.
Light sensor (LDR)
Feels light. Bright or dark changes how electricity flows.
555 timer chip
A small brain that switches things on and off on a timer.
Buzzer
Beeps when electricity flows.
Safety: 9 V battery only. Never wall power. No soldering.
Join Spark MakersCircuit Builders kit
Real chips, real tools. Students learn to measure, read datasheets, solder and code.
Logic gate chips
74HC08 AND, 74HC32 OR and 74HC04 NOT gates for alarms and decisions.
Counter chips
CD4017 for LED chasers and dice, CD4026 for number displays.
LM358 op-amp
Compares two voltages: the heart of the temperature alarm.
Transistors
BC547s let a small current switch a bigger one.
7-segment display
Shows numbers from 0 to 9 for counters and timers.
L293D motor driver
Runs motors forwards and backwards safely.
Potentiometer and thermistor
A turn knob and a heat sensor to control circuits.
Arduino Uno
The first microcontroller: write code that blinks, reads and reacts.
Multimeter
Measures voltage, current and resistance, like a doctor's stethoscope for circuits.
Soldering kit
Temperature-controlled iron, perfboard and eye protection, used with a teacher.
Safety: Battery packs and USB power only. Soldering at a temperature-controlled station with eye protection and a teacher beside every student.
Join Circuit BuildersPro Engineers kit
Engineering tools for building real products, from first code to a finished circuit board.
ESP32 Wi-Fi board
A fast microcontroller with Wi-Fi and Bluetooth built in.
ATmega328P and crystal
The chip inside an Arduino, used on its own on a breadboard.
BME280 sensor
Temperature, humidity and air pressure over I2C.
OLED display
A small sharp screen for readings, menus and graphs.
Robot chassis
Motors, wheels and line sensors for the PID robot.
Bench power supply
Adjustable low voltage with a current limit, up to 12 V.
Oscilloscope and logic analyser
See signals change over time and decode I2C and SPI.
Protected battery module
Rechargeable power with built-in protection.
Your own PCB
Designed in KiCad by the student and made by a PCB maker.
Safety: Low-voltage bench supply (up to 12 V), USB and protected battery modules only. Never mains.
Join Pro EngineersSafe by design
Short rules, repeated in every class.
- Low voltage onlyBatteries, USB or a limited bench supply. Never wall power.
- Battery off while buildingUnclip, change, then clip on again.
- Teacher checks important circuitsBefore the power goes on.
- Careful handsFingers and hair away from moving parts.
Ready to become a Tiny Maker?
Send us your child’s class and we will reply with the next batch details. No experience needed.
Or call